Getting error message in setup for linksys router. Says that it can't connect to ethernet port?

I am trying to run the wizard for linksys wrt54gl linksys router. However, when I connect all the wires and everything, the wizard loads, and then says that it cannot connect to the router and says that I'm not connected to it...I have checked and rechecked the cables, and even changed them. Everything works fine. What is the problem?





Thanks|||Reset router to DEFAULT: With a straightened paperclip, press RESET button 20-30secs.


=


Run the wizard again OR:


- - - - -


Connect Modem [wired] to Router [wireless] to PC.


=


* DO NOT REMOVE POWER TO RESET NETWORK DEVICES *


-


Set router POWER OFF.


-


Reset modem: With a straightened paperclip, press RESET button momentarily.


-


Wait 60 secs.


-


Set router POWER ON.


-


Reset router: With a straightened paperclip, press RESET button momentarily.


-


Wait 60 secs.


--


PC Command Line:


-


Click [Start] - Click [Run...] - enter: cmd, Click [OK]


-


At the prompt (c:\.....%26gt;) enter: ipconfig /release, press [ENTER]


-


At the prompt (c:\.....%26gt;) enter: ipconfig /renew, press [ENTER]


-


TEST: Open Web Browser: Connect to Internet.


--


If SUCCESS: Repeat Steps after PC Command Line on other PCs.


-


If NO SUCCESS:


-


At the prompt (c:\.....%26gt;) enter: ipconfig /all, press [ENTER]


-


Ensure DHCP Enabled == YES


-


If IP Address == 0.0.0.0 OR 169.254.0.0 to 169.254.255.255, connect Modem [wired] to Router [wired] to PC and perform ALL steps again.


-|||when setting up the connection do not plug the Ethernet in .The computer is reading the Ethernet cable .so cannot proceed to set up a wireless connection.unplug it, run the disk again.itll set up and find the wireless connection you may have to also set it up in connections, wireless connections. If your wireless router is pass worded you will need to know that info also. SSID Info and such.